Wadding
There are many wadding recipes floating around, so we decided to bring some together, and start doing some tests on them.
So far we have excluded high aluminium oxide recipes, partly because they are relatively expensive to mix up, and partly because they can leave a white mark on the clay, which I don’t find attractive.
Requirements
- Firm enough to support the pot, and able to stick to it
- Not welded to the pot by running glazes or flying ash
- Easily removed
- Neutral or attractive marks on the pot after the firing
- Moderate cost
Wadding Components
Wadding has the following major components:
- Aluminium based – the standard for soda and salt firing, but expensive and leaves white marks.
- Calcium – based on the traditional use of sea shells. The calcium carbonate in the shells is refractory, and calcium carbonate -> CaO with heat. Then it absorbs water when cold and should crumble away as it absorbs moisture after the firing
- Fireclay – highly refractory, acts as a resist, and also binds the wadding together to improve its wet properties
- Sand or grog – refractory materials, though don’t act as a resist or bind the wadding together
- Combustibles – sawdust, coffee grounds, flour…, all burn away early in the firing, leaving a porous wadding. The idea is that this then crumbles away easily, but it can also soak up ash or glaze, in which case the wadding is welded to the pot
Mixing
- Water – the handling properties of wadding seem to be very sensitive to the amount of water added, if anything being less tolerant than clay. Too much water, and the wadding won’t take any weight; too little and it crumbles.
- Maturing – wadding seems to improve with age, presumably the clay, sawdust etc all soaking up more water
Recipes
Note that all quantities are assumed to be by dry volume unless stated otherwise.Te comparison table at the end gives a quick comparison of the component types in each wadding.
Scallop Shells
Large and strong, ideal for big pots, but may need some wadding under them to make them sit better. Generally come off easily, unless they bond in with a glaze or lots of ash in which case they need grinding off, but leave attractive marks.
Cockle Shells
Similar to scallops but much smaller and weaker – need stuffing with clay to avoid a risk of collapsing. Good for small bowls etc, putting 3 round the foot
Kirk Mangus Fireclay Wadding
1 part each of silica sand, grog, sawdust and fireclay. No residue, leaves bare clay colour.
Tim Copsey recipe through Deniol Williams
1 part each of silica sand, sawdust and fireclay. See above.
Jean Sampson Salt Glaze Wadding
8 Alumina (either oxide or hydrated)
2 China clay
1 TWVD ball clay (or any dark or local)
1 Grog
Knead wheat flour into the mix to give a sticky consistency.
Used in the March 2020 firing for all wadding. It crumbles away very easily if it doesn't get saturated with running glazes or molten ash. Left white marks on some of the pots. Good for use on shelves and props, but not my favourite for pots.
Ben Brierley Recipes
A
2 silica sand
2 fireclay
2 kaolin
1 sawdust
Used in tunnel and lower back shelves in autumn 2019 firing. Holds shape well and also sticks well to the pots, so doesn’t tend to fall off when positioning the pots. Came off easily. No marks under the wadding, though may have caused some orange flashing around it on a low iron clay.
B
2 grog
2 fireclay
2 sawdust
Used in top back shelves in autumn 2019 firing. Not quite as good at holding shape or sticking to pots as A. Came off easily generally, but took a piece of pot off with it on at least 1 pot.
C
3 grog
3 fireclay
0.5 AT ball clay
0.5 red clay
3 sawdust
Recipes with ball clay or red clay leave a more attractive mark due to the iron, and come off very easily, more than if just fireclay. Possibly because the red clay softens early in the firing, making the wadding less porous and so less affected by absorbing glaze or wood ash.
D
1 alumina
1.5 silica sand
2.5 fireclay
1 sawdust
E
2 alumina
1 molochite 30 mesh
1 kaolin
1 sawdust
F
2 silica sand
1 fireclay
1.5 sawdust
His standard recipe, works well unless it gets saturated with ash.
G
1 alumina
2 silica sand
? fireclay
0.5 red clay
1.5 sawdust
Used in top shelves in autumn 2019 firing. Not quite as good at holding shape or sticking to pots as A or B. Came off easily.
Wobage
1 silica sand
1 fireclay
2 stoneware clay
4 sawdust
Very high sawdust. Used in middle back shelves in autumn 2019 firing, and under props and bottom shelves in front. Doesn’t hold shape, quite crumbly and pieces can break off and fall into pots. Comes off easily (though no glaze runs there) but doesn’t keep its shape under load. No visible marks. Best under bottom kiln shelves or on props as a wadding pancake.
Sargent
9 silica sand
1 fireclay
1 sawdust
Something wrong, doesn’t stick together. Possible transcription error, should be 1 of sand? Then same as Tim Copsey recipe above. Could only make it work by adding lots more clay.
Rose
1 silica sand
1 fireclay
Comparison Table
This gives a quick comparison. It doesn't differentiate between similar components, e.g. all clays are grouped together. Values have been normalised to add up to 10.
| Recipe | Al | Ca | Clay | Sand/grog | Combustible |
| Shells | 0 | 10 | 0 | 0 | 0 |
| K Mangus | 0 | 0 | 2.5 | 5 | 2.5 |
| T Copsey | 0 | 0 | 3.3 | 3.3 | 3.3 |
| J Sampson | 6.2 | 0 | 2.3 | 0.8 | >0.8 |
| BB A | 0 | 0 | 5.7 | 2.9 | 1.4 |
| BB B | 0 | 0 | 3.3 | 3.3 | 3.3 |
| BB C | 0 | 0 | 4 | 3 | 3 |
| BB D | 1.7 | 0 | 4.2 | 2.5 | 1.7 |
| BB E | 4 | 0 | 2 | 2 | 2 |
| BB F | 0 | 0 | 2.2 | 4.4 | 3.3 |
| BB G | 1.8 | 0 | >1.8 | 3.6 | 2.7 |
| Wobage | 0 | 0 | 3.8 | 1.2 | 5 |
| Sargent | 0 | 0 | 0.9 | 8.2 | 0.9 |
| Rose | 0 | 0 | 5 | 5 | 0 |
Information Sources
Active Wadding – Ben Brierley (and recipes link) http://www.ben-brierley-woodfired-ceramics.co.uk/Active_wadding_article.html
Wadding for Wood Firing by Simon Levin http://glinca.si/wp-content/uploads/2017/11/Ceramic-Arts-Daily_WoodKilnFiring.pdf
Wood Fired Ceramics by Coll Minogue and Robert Sanderson
<HR>
Licence
Tim Thornton Ceramics Technical by Tim Thornton is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Permissions beyond the scope of this license may be available at https://tim-thornton.com/tikiwiki/tiki-index.php?page=Licence.
If you re-use any material from this web site, you must include an attribution statement as described in the licence, and state if the work has been altered.
You may release work that modifies or builds upon this work only under the same licence (or a compatable one, as defined in the licence).
This licence does not permit you to use this work for commercial purposes, i.e. for commercial advantage or monetary gain. If you wish to use the work in this way, please contact us to discuss it. You will need our prior permission and approval to do this.
Whilst we aim to ensure that all material is accurate at the time of publication, we do not accept responsibility for decisions based on information we make available. No content of this site may be taken to be legal or medical advice.
Please bear in mind that materials on the website are the most up to date versions, but items you have downloaded in the past may not be. The materials are updated from time to time. We recommend that you use the latest versions by referring to those published on our website.
Exclusions
Images – Images are not available for re use under the OGL because in most cases copyright is held by a third party. The Council does not grant anyone any rights to re use images.
Use of logos – The use of Tim Thornton’s logos on any document or in association with any information, signifies that the document or information has been prepared or approved by him. The logos are to be used only when reproducing materials unaltered from the web site, to show their original source. If you wish to use the logo in any other way, please contact us first to obtain permission.
Third party intellectual property/copyright – We do not have the legal authority to grant permission to re use documents where legal rights are owned by third parties.
Applications for re-use
If you wish to make a specific application to re use information which does not conform with the CC BY-NC-SA 4.0 licence terms, please contact us to ask permission and for details of what, if any, additional conditions and/or charges may apply. Your application should be in writing, specifying your name and address and, identifying the information source you want to re-use and the purpose for re-use.
Disclaimer
Whilst every care has been taken in the compilation of this website, and every attempt made to present up-to-date and accurate information, we cannot guarantee that inaccuracies will not occur. We will not be held responsible for any loss, damage or inconvenience caused as a result of any inaccuracy or error within these pages.
Links from our site may lead to pages maintained by other organisations. These are provided purely for your convenience, and do not imply that we endorse or support those organisations, the information on their pages, or their products or services in any way. Additionally, no responsibility is assumed by us for the contents of its pages.